User Manual

Installation

Inserting the standard battery

Aastra 610d, 620d

Push the battery cover downwards until it disengages

from the locking mechanism and lift off. Insert the bat-

tery with the contacts downwards. Replace the battery

cover and push upwards until it snaps into place.

Aastra 630d

Undo the two screws on the back of the handset with a

suitable tool and remove the cover. Insert the battery

with the contacts downwards, close the battery com-

partment with the cover and screw back in place. Do

not damage the rubber seal when assembling.

Inserting the power battery

You can order a battery with higher capacity

(power battery) for the Aastra 620d and 630d

as an accessory (see page 61).

This battery has a thicker design so you need another

battery cover that protrudes approx. 6 mm beyond the

rear of the device.

Install the new battery cover as described above.

In the Aastra 620d you should remove any installed

fixing bracket beforehand.

This EUT has been shown to be capable of compliance for localized specific absorption rate (SAR) for

uncontrolled environment/general population exposure limits specified in ANSI/IEEE Std. C95.1-

1992 and had been tested in accordance with the measurement procedures specified in FCC/OET

Bulletin 65 Supplement C (2001) and IEEE 1528-2003.

Industry Canada (Canada only)

Operation of this device is subject to the following two conditions: (1) this device may not cause

interference, and (2) this device must accept any interference, including interference that may cause

undesired operation of the device.

Privacy of communications may not be ensured when using this telephone.

Exposure to Radio Frequency (RF) Signals:

The wireless phone is a radio transmitter and receiver. It is designed and manufactured not to

exceed the emission limit for exposure to radio frequency (RF) energy set by the Ministry of Health

(Canada), Safety Code 6. These limits are part of comprehensive guidelines and established permit-

ted levels of RF energy for the general population. These guidelines are based on the safety stan-

dards previously set by international standard bodies. These standards include a substantial safety

margin designed to assure the safety of all persons, regardless of age and health.

This device and its antenna must not be co-located or operating in conjunction with any other

antenna or transmitter.

This device has been shown to be capable of compliance for localized specific absorption rate (SAR)

for uncontrolled environment / general public exposure limits specific in ANSI/IEEE C95.1-1992 and

had been tested in accordance with the measurement procedures specified in IEEE 1528-2003.

General information