User Manual

Installation

Headset connection/

Bluetooth

All handsets have a 2.5 mm jack plug at the bottom left for connecting a headset. Only use the

recommended headsets (see Accessories page 61).

The Aastra 620d/630d mobile handsets have a

Bluetooth

interface (2.0) for corresponding headsets.

With a headset only audio data can be transferred via the

Bluetooth

interface.

Aastra 630d - Headset: To remove the sealing cover

The opening of the headset connection is closed with a captive cover. If the headset is not in use,

please close the opening so the device can be used in accordance with its protection class.

Remove the sealing cover from the device by pulling it out on the upper edge. Never pull it out on

the bottom edge.

Installation

Installing/removing a mounting bracket or rotary clip

Aastra 610d, 620d

Place the supplied fixing bracket on both openings at

the upper end of the handset and snap in place by

pressing downwards. To remove the fixing bracket,

press into the small cutouts at the edge of the bracket

and pull the two sides slightly apart.

The Aastra 610d and 620d can also be fitted with

a rotary clip as an accessory. Place the supplied fixing

bracket on both openings at the upper end of the

handset and snap in place by pressing downwards. The

clip is then pushed onto the protruding button. To

release the handset from the clip, press the top button.

Attaching the carrying strap

Aastra 610d, 620d: There are two openings

in the upper part of the fixing bracket. Feed the lower

end of the carrying strap through these openings (ple-

ase install with the fixing bracket removed). Carrying

straps are available as accessories (see page 61).

Aastra 630: A carrying strap with carrying strap

attachment is available as an accessory. To

attach the holder, replace the screwed-on belt

clip by the carrying strap attachment.