User Manual

OpenMobility SIP Installation, Administration and Maintenance
Aastra DeTeWe Doc-ID: pm-0504 28.11.2006 Page: 25 (52)
3.2 Static local configuration of the IP DECT Base Station
For a static local configuration you must use the java configuration tool
OpenMobility Configurator (requires Java Runtime Environment version 1.4
or higher).
The settings, which are configured on the IP DECT Base Station with the tool
OM Configurator, will be saved permanently in the internal flash memory of
an IP DECT Base Station.
The parameters configurable via the OM Configurator comply with the DHCP
option, please see section 3.1 for details.
If a local static configuration has been done, DHCP is not used anymore.
The following figure shows the OM Configurator.
To configure an IP DECT Base Station, at least the MAC address and all
mandatory options (see table below) have to be set. If the IP DECT Base
Station has an IP address enter this address in the IP address field. In this
case you can reach the IP DECT Base Station from outside the local LAN
segment.
To set additional parameters, press the “Add parameter” button and choose
the desired parameter.
Press the “Send configuration” button to transmit the parameters to an IP
DECT Base Station.
The configuration can only be set after powering up or at the retry phase
(LED flashing 0,25 Hz) or in kernel mode, please see section 3.1.6 for
details. The configurator tool waits 2 seconds and retries transmitting the
data 3 times.