User Manual

OpenMobility SIP Installation, Administration and Maintenance
Aastra DeTeWe Doc-ID: pm-0504 28.11.2006 Page: 31 (52)
3.3.3.1.2 Encryption
Encryption is only available if RFP32/34 IP (not RFP 31/33 IP) are used.
Therefore it can only be enabled on the “System Settings” web page if no
RFP31/33 IP has been connected to the OMM.
If encryption is enabled and an RFP31/33 IP connects to the OMM, its DECT
air interface will not be activated. The user always has the possibility to
disable encryption. In this case all connected RFP31/33 IP are restarted.
Note: The PPs have to support DECT encryption which is not a mandatory
feature.
3.3.3.1.3 Regulatory domain
To define where the IP DECT is used the parameter regulatory domain has
to be configured. Existing installations are updated to the default value
“EMEA (ETSI)”. To setup an FCC compliant installation the value has to be
set to “US (FCC/CI)”.
ETSI compliant RFPs are inactive and can not be activated if the regulatory
domain is set to “US (FCC/CI)” and vice versa.
3.3.3.2 SIP
The SIP settings cover all global settings matching the SIP signalling and the
RTP voice streams.
• Proxy Server
IP address or name of the SIP proxy server.
• Proxy Port
SIP proxy server’s port number. Default is 5060.
• Registrar Server
IP address or name of the SIP registrar. Enables the PPs to be registered
with a Registrar.
• Registrar Port
SIP Registrar’s port number. Default is 5060.
• Registration Period
The requested registration period, in seconds from the registrar.
• Outbound Proxy
Address of the outbound proxy server. All SIP messages originating from
the OMM are sent to this server. For example, if you have a Session
Border Controller in your network, then you would normally set its address
here.
• Outbound Proxy Port
The proxy port on the proxy server to which the OMM sends all SIP
messages.