User Manual

OpenMobility SIP Installation, Administration and Maintenance
Aastra DeTeWe Doc-ID: pm-0504 28.11.2006 Page: 41 (52)
upper right side refers to the PARK 1F-10-F2-21 of the IP DECT system and
to the RFP to which the phone is currently connected to.
4.4.2 Aastra Phone 142 auto call test mode
You can set the Aastra Phone 142 to “auto call test mode” with a few
keystrokes. In this mode the phone will call a specified number cyclically. You
can use this feature to generate traffic for test purposes. This mode is also
active if the phone is an the charger.
1) Press the “Menu” soft key
2) Enter the following key sequence “R***76#”
3) Select “Auto Call Test”
4) Press “OK”.
5) Enter the phone number to call.
6) Press “OK”.
7) Enter a number of seconds between two calls.
8) Press “OK”.
9) Enter a number of seconds a call shall be active.
10) Press “OK”. The test will be started automatically.
To stop the test, switch the phone off and on again.
4.4.3 Aastra Phone 142 auto answer test mode
You can set the Aastra Phone 142 to “auto answer test mode” with a few
keystrokes. In this mode the phone will answer incoming calls automatically.
You can use this feature together this phones in the “auto call test mode” for
test purposes. This mode is also active if the phone is an the charger.
1) Press the “Menu” soft key
2) Enter the following key sequence “R***76#”
3) Select “Auto Answer”
4) Press “OK”.
5) Enter a number of seconds the phone shall ring before it will answer the
call.
6) Press “OK”.
7) Enter a number of seconds a call shall be active.
8) Press “OK”. The test will be started automatically.
To stop the test switch the phone off and on again.
4.4.4 Syslog
The OpenMobility Manager and the RFPs are capable of propagating syslog
messages conforming to /8/. This feature together with the IP address of a
host collecting these messages can be configured.
Syslog has to be enabled by