User's Guide

Model / User Guide 10
Programming Feature Key
Programming Feature Key
The Feature key permits the programming of the following functions. The default
functions are marked in bold.
Programming Guideline
The following is a guideline to use when programming the Feature key:
All handsets will have the same programmed functions since the web interface
apply to all the handsets that are paired with the base.
A newly registered handset or handset that was out-of-range during the
programming will need to perform a "off-hook and on-hook" sequence in order
for the newly programmed function to be broadcasted to the affected handsets.
Simply press the v key from the idle state to go off-hook. Then, press the ∫
key to go back on-hook.
Duplicate function can exist in the Feature key as there is no filtering or duplicate
checking done on the handset or the base.
If no line keys are programmed for the Feature key, the handset will be restricted
to intercom calls only.
If all 12 programmable functions have been programmed to "None", the user will
be presented with a List empty message when the Feature key is pressed.
For security reason, the user has 180 seconds (3 minutes) to complete the
programming. Otherwise, the phone will respond with the following error: **
Error **: Session expired, Please reload page.
Label Key Function
None No function is selected – this key is empty, no label.
Line 1 Line 1 key - Selects line one
Line 2 Line 2 key - Selects line two
Line 3 Line 3 key - Selects line three
Line 4 Line 4 key - Selects line four
Icom Intercom key – Enter handset list to select handset to call
Dir Directory key – Activate directory feature
Callers Callers key – Activate callers feature
Xfer Transfer key - Activate transfer feature
Conf Conference key - Activate conference feature
Public Public key – Toggle between public & private call mode
Line 5 Line 5 key (if available) - Selects line five
Line 6 Line 6 key (if available) - Selects line six
Line 7 Line 7 key (if available) - Selects line seven
Line 8 Line 8 key (if available) - Selects line eight
Line 9 Line 9 key (if available) - Selects line nine
List empty
Use web page to
configure