Owner`s manual

82
The default is that all extensions are set for 25 Hz ringing.
Inverting ringing cadences
The external and Internal ringing cadences can be interchanged on
an extension by extension basis.
From the Programming Extension, press the PROGRAM Key
Select ‘System programming’.
Enter the System Programming Password and select 'Extensions'.
Press the Scroll Down Key () until ‘Reverse Cadence ' is
displayed.
Select 'Reverse Cadence'.
Select the extensions that require the cadences changed
Keypad Feedback
When off hook on an extension fitted with a Desk Phone, a
confirmation tone is played when a digit is pressed. This is so that
the user knows that a digit was dialed.
From the Programming Extension, press the PROGRAM Key
Select ‘System programming’.
Enter the System Programming Password and select 'Extensions'.
Press the Scroll Down Key () until ‘Keypad Feedback' is
displayed.
Select 'Keypad Feedback'.
Select the extensions that require the confirmation tone to be
played.
To configure CO lines
There are various options to configure the CO line interfaces on
your system. It is recommended that these settings should only be
altered from the original settings if there has been a change in the
network connection.
From the Programming Extension, press the PROGRAM Key
Press the Scroll Down Key () until ‘System programming’ is
displayed.
Select ‘System programming’.
Enter the System Programming Password and select ‘Lines’.
Press the Scroll Down Key () until ‘CO Programming’ is displayed.
Select ‘CO' programming’.
Select the desired option as detailed in the table below. The
options are either explained in the following pages or in the
referenced pages
Press the Speakerphone Key to finish programming.
CO Programming Option Default setting Alternate setting
Caller ID Detection Caller ID is set depending on
the information provided during
ordering
Caller ID set
Dialtone detection Off On
Long CO Line Off On