Technical information

Maintenance Commands
111
Maintenance
Commands
DS1/CEPT Formatter I Card (MC263CA
and MC264CA) Communications
Use the following VT100 terminal emulation settings and
commands when communicating with a DS1/T1 Formatter I
card (MC263CA) or CEPT Formatter I card (MC264CA).
Settings
Use the following VT100 terminal emulation settings:
Baud rate: 38,400 bps
Databits: 8
Parity: N
Stop bits: 1
No flow control.
Commands
Use the following commands:
sig cas
Sets the signaling to CAS (default T1).
sig dpnss
Sets the signaling to DPNSS (default CEPT).
+dchan-inv (T1 only)
Sets D-channel inversion to ON (default).
-dchan-inv (T1 only)
Sets D-channel inversion to OFF.