Technical information

Technician’s Handbook
120
Flowchart 3: An Alarm is Present
Enter this command:
SHOW STATUS ALARMS
The terminal displays the alarm category.
Enter:
SHOW FAULTS <alarm category>
The system displays the alarm category and
identifies the faulty card or device.
Record the name and the physical location
identifier (PLID) of the faulty card or device.
An alarm is present.
Flowchart 3:
Replace the faulty card or device. See
Replacing Circuit Cards on page 146 and
Recovering from a Corrupted Hard Disk on
page 140. See also, the SX-2000 Install
Upgrades and FRUs (Field Replaceable
Units) section of the Technical Documentation
CD-ROM.
Enter:
STATE <PLID> of the faulty card or device.
Enter:
TEST <PLID> of the faulty card or device.