Technical information

Troubleshooting and Repair
127
Troubleshooting
Flowchart 6: Maintenance Terminal Troubleshooting
Were you able to
correct the fault?
See the SX-2000 Maintenance Terminal
troubleshooting procedure on theTechnical
Documentation CD-ROM for further possible
corrective actions.
Refresh the terminal screen by typing
[Ctrl] W.
Ensure that the terminal baud rate is
set correctly. Default rate is
8N1
ASCII character set
Xon/Xoff flow control
9600 baud
Pin 4 & Pin 20 high
Troubleshooting
complete.
Yes
Try using other baud rates
(for example, 1200).
No
Flowchart 6:
Maintenance terminal
troubleshooting
Res
et the terminal by pressing [Ctrl] Q on
the keyboard or by resetting the power. Enter
[Ctrl] C to cancel any active commands.