Technical information

Troubleshooting and Repair
131
Troubleshooting
- Enter YES.
- Remove the datasave RSD.
- Hold down PANEL ENABLE and press the inactive
plane’s RESET button.
- Return to step 5 of this procedure and continue.
10.Enter:
VOL DISMOUNT <volume name of RSD>
11.Remove the RSD.
12.Enter:
DBMS SAVE.
When the save is complete, the system delivers the
following message:
DBMS info: Save Completed
13.Switch activity. Service is lost for 5 to 15 minutes.
14.Enter JOIN first from the newly inactive plane, and then
from the newly active plane.
When the JOIN command is entered, the system
delivers the following messages and prompts:
ENTER: <YES> if both planes have the same S/W
version, <NO> to cancel JOIN.
Enter YES.
After the operation is complete, this message appears:
System JOIN completed.
15.Ensure the databases on both drives are in synch by
entering FIL ST RED.
16.Hold down PANEL ENABLE and press ACTIVITY
FREEZE OFF.
17.Perform the procedure Checking a Redundant System
on page 158.
10 min
15 min