Technical information

Routine Maintenance
171
Routine
Maintenance
Load the Operating System Software from RSD
1. Insert the software RSD in the RSD drive.
2. Hold down PANEL ENABLE and press A RESET.
Service is lost until you complete the DATA
RESTORE.
3. Log on to the system and select maintenance mode.
4. If you are upgrading from software previous to Q26.13.1,
proceed to step 5; otherwise, proceed to step 6.
5. Enter:
FILE DIS RED
This message appears:
FS error: File system redundancy could not be disabled.
Reason: No such volume.
FS warning: Local disable can be attempted (Note: can lead to
FS corruption).
FS info: Continue? (yes/no)
Enter YES
OR
This message appears:
FS info: File system redundancy disabled.
DBMS warning: Unable to read/write state file. Reason: Node
does not exist.
DBMS error: Download failed. Reason: Node does not exist.
6. Enter:
VOL DISMOUNT SYSUSER
7. This message appears:
FS info: Dismounted volume from device DISK with name:
SYSUSER
8. Enter:
VOL FORMAT DISK SYSUSER LOAD $8000 REDUN
$10000 SCRATCH
This message appears:
FS info: Continue?
Enter YES
3 min