Technical information

Technician’s Handbook

172

When formatting is complete, this message appears:

FS info: Formatted volume on device DISK with name:

SYSUSER

Enter:

VOL RESTORE SYSUSER FROM RSD

This message appears:

FS info: Start of Restore.

When the system has copied the system software from

the RSD to the hard disk, this message appears:

FS info: Restored volume from device RSD with name:

SYSUSER

9. Remove the software RSD from the RSD drive.

10.Hold down PANEL ENABLE and press A RESET.

11.Log on to the system and select maintenance mode.

12.Re-insert the software RSD in the RSD drive.

13.Enter:

VOL MOUNT RSD

Read the volume name of the RSD from the system

response on the maintenance terminal.

14.Enter:

UPDATE APPLY <volume name of RSD> FROM

∗.<volume name of RSD>

This message appears:

Update started.

Update applied successfully

If there are no updates, this message appears:

ERROR: No update files were found

The update has NOT been applied

Ignore this error and go to the next step.

15.Enter:

VOL DISM <volume name of RSD>

16.Remove the software RSD from the RSD drive.

RSD 5 min

Tape 60 mi

10 min