Technical information

Technician’s Handbook
174
10.Hold down PANEL ENABLE and press A RESET.
11.Go to Restore the Database on page 174.
Restore the Database
1. Insert the datasave RSD in the RSD drive.
2. Log on to the system and select maintenance mode.
3. Enter:
VOL MOUNT RSD
Read the volume name of the RSD from the system
response on the maintenance terminal.
4. If you are loading software P02.3.2 or later, enter:
DATA RESTORE ∗.<volume name of RSD>
If you are loading software earlier than P02.3.2, see Data
Restore or Data Convert? on page 168 to determine
which command to use in this step.This message
appears:
Delete old log file? (Yes/No)
Enter YES
This message appears:
Existing Data Save will be deleted from Harddisk. Continue?
(Y/N)
Enter YES
These messages appear:
FS info: Deleting files from catalog ∗.DR.CONFIG
FS info: Deleting file ∗.DR.CONFIG.TIMESTAMP
•
•
If your software is load P02.3.2 or later, this message appears:
Restore system dimensions from saved data?
If you have NOT enabled new options
• Enter YES and proceed to step 5
If you HAVE enabled new options (or entered them
manually)
10 min
RSD 15 mi
n
Tape 60 mi
n