Technical information

Routine Maintenance
179
Routine
Maintenance
6. Remove the RSD.
7. Enter:
DBMS STAT
The initialized flag should be on.
8. Hold down PANEL ENABLE and press A RESET.
Service is lost for 5 to 15 minutes.
9. Log on to the system and select maintenance mode.
10.Reload the software into all peripheral processors, DSU
cards, DNI line cards, and attendant consoles.
For software loads P17.6.4 and later, enter:
LOAD CONTROLLERS
For software loads earlier than P17.6.4,
– Turn power to SUPERSET 700 consoles off and then
on again.
– Load DNI line cards. Enter:
LOAD <cabinet> <shelf> <slot>
11.Enter:
VER
To display the update version.
12.Perform the procedure Checking a Non-redundant
System on page 157.
13.The software update is complete.
Performing a Software Upgrade on a Redundant System
To Perform a Software Upgrade (Overview)
1. Save the database to RSD.
2. Load the new operating software from RSD to the
inactive plane.
3. If new feature options have been purchased, or this is a
new install, or you are loading software that is earlier
than P02.3.2, enable new options.
15 min