Technical information

Technician’s Handbook
18
Comments: Enter the location of the new cabinet.
For MICRO LIGHT systems, refer to Figure 4 (page 12)
to determine the letter designation for your card
configuration. From Table 1 (page 13), locate the cabinet
assignment form that has the same letter designation as
your card configuration. Enter the table data into the
Cabinet Assignment form.
The following step takes the system out of service.
3. Commit the form. The system goes out of service.
4. After service is restored, enter the System Configuration
form and program the peripheral interface cards into the
new cabinet.
5. If your system is redundant, hold down PANEL ENABLE
and press ACTIVITY FREEZE OFF.
If the Maximum Number of Cabinets is Not Selected
Non-redundant Systems
1. Save the database to RSD (see page 164).
2. Ensure that you have removed the RSD from the RSD
drive.
3. Enable the options (see page 194).
Enter 5 for the maximum number of cabinets in the
Dimension and Feature Select form. Note that a new
password is not required.
4. Complete the Cabinet Assignment form.
For MICRO LIGHT systems, refer to Figure 4 (page 12)
to determine the letter designation for your card
configuration. From Table 1 (page 13), locate the cabinet
assignment form that has the same letter designation as
your card configuration. Enter the table data into the
Cabinet Assignment form.