Troubleshooting guide

Troubleshooting Guide
190
• VLAN ID and priority (current and static)
• DSCP value
• IPA IP address (current and static)
• TUG IP address (static)
• TFTP SVC IP and port (static).
To view and modify network parameters:
1. Access the Configuration Menu (see page 188).
2. At NETWORK PARAMETERS?, press Yes. VIEW CURRENT VALUES? appears.
3. Do one of the following:
- Press Yes, and then press the Up/Down volume keys to view each setting. When you
return to VIEW CURRENT VALUES?, press No. VIEW STATIC VALUES? appears.
- Press No. VIEW STATIC VALUES? appears.
4. Do one of the following:
- Press Yes, and then press the Up/Down volume keys to view each setting. When you
return to VIEW STATIC VALUES?, press No. MODIFY STATIC VALUES? appears.
- Press No. MODIFY STATIC VALUES? appears.
5. Do one of the following and then reboot the phone:
- Press Yes, and then press the Up/Down volume keys to scroll through each setting.
Use the keypad to modify parameter(s), and then follow the prompts to store the
changes and reboot the phone.
- To reset the factory defaults, press Default, and then follow the prompts to set and
store the factory defaults and reboot the phone.
6. To exit the current menu without a reboot:
- To return to the main menu, press Yes at EXIT MENU?
- To return to the default display, press Superkey. (On the 5560 IPT, press Cancel or
# to reach the exit menu and then follow the display prompts.)
Configuring Hardware Components
You can configure the speed and duplex for the LAN and PC ports.
To manually configure hardware components:
1. Access the Configuration Menu (see page 188).
2. Press No until HARDWARE CONFIG? appears, and then press Yes. MODIFY SETTINGS?
appears.
3. Do one of the following and then reboot the phone:
- To modify the current hardware components, press Yes, and then follow the prompts
to modify each setting and store the changes.
- To reset the factory defaults, press Default, and then follow the prompts to set and
store the factory defaults.