Troubleshooting guide

Diagnosing Problems
211
Resiliency
Locating Resilient Devices
Use the following three Locate commands to obtain information for resilient devices.
• Locate Extension
• Locate Feature
• Locate Remote
Locate Extension
You issue the Locate Extension command to acquire information about the 3300 ICP of a
resilient or non-resilient extension. For resilient devices, the output of the command
• Provides primary and secondary ICP cluster element index numbers and routing digits
• Identifies the ICP the locate command was issued on (“LEID”)
• Indicates the location of the resilient device by placing an asterisk (*) beside the primary
or secondary ICP that the device is in service on
Table 71. ‘Locate Extension Information for Resilient and Non-resilient Devices” p. 212
provides the input and different possible outputs for the Locate Extension command.
Note: To determine the state (in service, out of service, idle, busy, and so on) of the
device on a given ICP, you must issue the State Extension command. For an overview
of this command, see “State Extension” on page 215, and for more detailed information,
refer to the 3300 ICP General Information Guide and 3300 ICP System Administration
Tool Online Help).