User guide

5330/5340 IP Phones – User Guide
103
USING THE LINE INTERFACE MODULE
Your phone supports the Mitel Line Interface Module. The Line Interface Module allows you to
make and receive calls over an analog line (Line Interface Module line) connected to your phone.
The Line Interface Module operates in either of the following two modes, as determined by your
System Administrator:
• Line Interface Module Mode: your phone allows you to use the Line Interface Module
line at any time
• Failover Mode: you can use the Line Interface Module line only when the IP connection
has failed
Note: Handsfree and on-hook dialing are not supported on the Line Interface Module line.
For information on emergency number dialing using the Line Interface Module, refer to
Emergency Calls.
Making and Answering Calls Using the Analog key
To make a call using the Analog line:
1. Lift the handset.
2. Press the key you programmed as Analog Line.
ANALOG CALL is displayed.
3. Dial the number.
Note: When you make an external call over the analog line, a prefix dialing number is not
required. If your phones Analog Line key has the Privacy option enabled, you cannot
access the analog line when another phone is using the analog line (key is solid
orange).To access the analog line, the user of the other phone must first hang up. To
determine whether the Privacy option is enabled, contact your System Administrator.
To answer a Call using the analog line:
1. Lift the handset.
2. Press the Analog Line key that is highlighted.
To answer a waiting call on the analog line:
Note: If you have subscribed to an analog call waiting service, you may use the hookswitch or
press Cancel ( ) to answer a waiting analog call. When you are on an analog call and a
waiting analog call arrives, you hear a beep. This feature may not be supported in all
regions.
To answer a waiting analog call or return to the original analog call: