IP Phone User Manual

-31-
Headset Operation
To enable Headset Operation on telephones that are not programmed
for full-time headset mode:
z Press the Headset feature key.
To answer a call (when Auto Answer is disabled):
z
Press the flashing line key.
To hang up:
z
Press CANCEL.
Headset Operation (Headset with Feature Control Switch)
IMPORTANT NOTE: Headsets with a feature control switch that are
approved for use with the 5215 IP phone must be installed in the dedicated
headset jack (the jack nearest the front of the phone). Installation will
disable your handset microphone. Disconnecting the headset at the jack or
at the quick-disconnect plug restores handset operation. If handset
operation is required for an extended period of time, you should press the
Headset feature key to return the telephone to handset mode.
To answer a call:
z
Press the flashing Line Appearance key
-
OR
-
Quickly press and release the headset's feature control switch.
To mute the headset microphone:
z
Press and hold the headset's feature control switch.
To hang up:
z
Press CANCEL.
-OR-
Quickly press and release the headset's feature control switch.
Music
To turn Music on and off when the phone is idle:
• Press the Music feature key.