User guide

Mitel

Model 5330/5340 User Guide – Issue 2, October 2008 Page 9

Personalizing Your Endpoint

This chapter describes features you can use to personalize your endpoint.

Adjusting the Viewing Angle

You can tilt the endpoint stand for a better view of the buttons and display.

To adjust the viewing angle:

1. Turn the endpoint so it faces away from you.

2. Hold the base firmly, and then press the tabs on the sides of the stand to release and

detach the base unit.

3. Hinge the hooks on the base unit into the notches on the back of the endpoint, and then

snap into place as follows:

• For a high-angle mount, hinge the two lower hooks into the bottom set of notches,

and then snap the two upper hooks into the middle set of notches.

• For a low-angle mount, hinge the two lower hooks into the middle set of notches,

and then snap the two upper hooks into the top set of notches.

Press tabs on both sides

to release and detach unit.