Installation guide

92 RN-001039-00 REV00 - 10.2014
Issues Resolved in Release 4.0.0
This section describes the issues resolved on the IP Phones in Release 4.0.0.
The following table provides the issue number and a brief description of each fix.
Issues Resolved
Note:
Unless specifically indicated, the resolved issues below apply to the 6863i, 6865i,
and 6867i IP phones.
Issue Number Description of Fix
Configuration
ENH28692/CLN37586 6867i: An enhancement has been implemented in Release 4.0.0 whereby mul-
tiple Network Time Protocol (NTP) time servers can now be configured on the
phone using DHCP Option 42.
DEF34938/CLN37989 6867i: The Disable Silence Suppression setting found in the Codec Preference
List on the Web UI was not dynamic. This issue has been corrected and the set-
ting is now applied dynamically if changed.
DEF35428 6867i: Park and Pickup settings (i.e. “Park Call” and “Pick Up Parked Call”) are
now available to be configured through the Web UI under the Preferences
menu in Release 4.0.0.
DEF35698 A issue was observed whereby, if the “https user certificates” parameter was
defined with file location containing no subdirectories (e.g.
http://mitel.com/CA.crt) the phone did not parse the location correctly. This
issue has been resolved.
DEF37682/CLN38650 6867i: If the time was set manually on the phone, the phone would only dis-
play the correct time when the time zone was configured as US-Eastern. This
issue has been corrected.
DEF33779/DEF38630 6863i: Various headset issues have been fixed and headsets are now fully sup-
ported (through the modular RJ9 handset jack on the back of the phone) in
Release 4.0.0 for the 6863i.
DEF37752 The configuration parameter “ring audibly enable” was not functioning as
expected in some previous firmware releases. This issue has been corrected.
DEF37925 When the SIP DSCP and RTP DSCP settings were configured with identical val-
ues, an issue was observed whereby users were unable to save the changes to
the Network Settings page of the phone’s Web UI. This issue has been
resolved.
DEF37928/CLN37975 The park/pickup feature when using the Park Pickup Config setting through
the Web UI was not functioning as expected. This issue has been fixed and the
setting now fully functional in Release 4.0.0.