General Xtreme- User Guide

Battery Information

■

Caution

In order to avoid damage to the battery, only use the Mitex

charger provided. The supplied charger is an ‘intelligent’

charger and has automatic and overload-protect functions

built in.

Do not short-circuit the battery pack or dispose of it in a fire.

The optimal charging temperature is between 10°C and 35°C.

When charging in temperatures below 10°C there may be a

leakage of electrolyte which will damage the battery. If charging

above 35°C, battery performance will be reduced.

■

Battery Charging

Connect the AC adaptor to the charger. The red LED will light.

Place the battery or the radio (switched off) with battery attached

into the charger (check that the battery is properly in place). The

red light will begin to flash – indicating that charging is in progress.

The LED will turn green when the battery is fully charged.

(see illustration 1)

illustration

Accessories Installation

■

Installing and Removing the Battery Pack

Place the rechargeable battery pack onto the back of the radio. (It will

only fit in one way). Snap the battery pack into place until you hear a

click. Check that the battery pack fits tightly in place against the body

of the radio. (See illustration 2)

Illustration

To remove the battery pack, make sure the radio is off first, then pull

back on the release catch and lift the battery pack from the body of

the radio. (See illustration 3)

Illustration