General Xtreme- User Guide

Function and Operation

■

Receiving

When radios receive any signal, the LED indicator will turn green. You

can hear the call if the tone is correct.

Note: If the transceiver is set to a higher squelch level, it may fail to

hear the call. If the LED indicator turns green but you cannot hear the

call, it means the signal has a matching carrier but does not have a

matching CTCSS/DCS code.

■

Transmitting

Hold【PTT】or 【Sub-PTT】to start transmitting. Please hold the

Scan Function

Turn the channel selector knob fully clockwise to reach channel 16.

The radio will then begin to scan. When a busy channel is found,

the radio will remain in scan mode for 5 seconds after the transmit-

ion has ended. To end the scan, rotate the channel selector to any

channel between 1 and 15.

There are two kinds of scan modes: ordinary scan and priority scan

(a programmable setting)

1. Ordinary scan

microphone approximately 2.5~5.0cm from your mouth, and then

speak into the microphone in your normal voice.

CH1 → CH2 → CH3 →

→ CH16

Note: The LED indicator will turn red when transmitting, release PTT to

standby or receive calls.

2. Priority scan: provided that priority scan channel is set to Channel

3, the scan sequence is as follows:

■

TDR(Dual Standby)

CH1 → CH3 → CH2 → CH3 → → CH16

■

CTCSS/DCS

Allows the user to select a specific CTCSS/DCS code per channel

– set by Mitex

Set by Mitex