User's Manual Part 2

Chapter 10 The VoIP Account Screens
BM2022w User’s Guide
172
10.6 Dialing
Click VoIP > Account 1 (or Account 2) > Dialing to configure dialing timeout values.
Figure 98 VoIP > Account 1 (or Account 2) > Dialing
MWI (Message
Waiting
Indication)
Select this to enable Message Waiting Indicator (MWI) function for this SIP
account specified in
Section 10.4 on page 169. When there is at least one new
voicemail for the SIP account, the voice LED (described in Section 1.2.1 on
page 19) turns yellow and the BM2022w sends a beeping tone to the phone
while user picks-up the phone to make calls.
DTMF
DTMF Control how the BM2022 handles the DTMF tone relay to the communication
peer. The DTMF tone is generated by the phone when you push its digit
buttons during a call. One application is to send numbers when trying to do
IVR (Interactive Voice Response) service with server.
You should use the same mode as your VoIP service provider. The choices are:
• Out-of-band(RFC 2833) - Follow the RFC 2833 standard and send the
DTMF tones in RTP packets.
• In Band - Send the DTMF tones in the voice data stream. This works best
when you are using a codec that does not use compression (like G.711).
Codecs that use compression (like G.729) can distort the tones.
SIP INFO
Select this to have the BM2022w send the DTMF tones in SIP messages.
Call Forward Setting
Unconditional
CF,
Unconditional
CF Target
Select this if you want the BM2022w to forward all incoming calls to the
specified phone number, regardless of other rules in this Call Forward Setting
section. Specify the phone number in the Unconditional CF Target field.
Note: The Unconditional CF function should be used very carefully, since
enabling this function makes the BM2022w forward all incoming calls to
another phone number, so the user would never know if there are any
incoming calls.
Busy CF,
Busy CF Target
Select this if you want the BM2022w to forward incoming calls to the specified
phone number if the phone port is busy. Specify the phone number in the
Busy CF Target field. If you have call waiting, the incoming call is forwarded
to the specified phone number if you reject or ignore the second incoming call.
No Answer CF,
No Answer CF
Target, No
Answer CF
Waiting Time
Select this if you want the BM2022w to forward incoming calls to the specified
phone number if the call is unanswered. Specify the phone number in the No
Answer CF Target field on the right. Specify the time to wait before
forwarding incoming calls in the No Answer CF Waiting Time field.
Call Waiting Setting
Call Waiting
Select this to enable call waiting for this SIP account on the BM2022w.
Call Waiting
Reject Time
Enter time to wait before rejecting a call when call waiting is enabled.
Table 75 VoIP > Account 1 (or Account 2) > Feature
LABEL DESCRIPTION