User's Manual Part 2

Chapter 12 Maintenance
BM2022w User’s Guide
193
12.9 Date
Use these settings to set the system time or configure an NTP server for automatic time
synchronization.
Click Maintenance > Date/Time > Date to open this screen as shown next.
Figure 114 Date Screen
This screen contains the following fields:
12.10 Time Zone
Use this screen to set the time zone in which the WiMAX device is physically located.
Click Maintenance > Date/Time > Time Zone to open this screen as shown next.
Figure 115 Time Zone Screen
Table 90 Date
LABEL DESCRIPTION
Manual
New Time
Enter the new time in this field.
New Date
Enter the new date in this field.
Get from Time Server
Time Protocol Select the time service protocol that your time server uses.Check with your ISP
or network administrator, or use trial-and-error to find a protocol that works.
• NTP (RFC 1305) - This format is similar to Time (RFC 868).
Time Server
Address 1~4
Enter the IP address or URL of your time server. Check with your ISP or network
administrator if you are unsure of this information.