Instruction Manual

X
Select Navi in the main function bar by
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
X
Select Avoid area and press W to con-
firm.
If you have not yet set an area to be avoi-
ded, a menu appears (option 1).
If you have already set one or more areas
to be avoided, a list appears (option 2).
Option 1: the menu appears
X
Select Using map, From memory or From
personal POIs and press W to confirm.
If you select Using map, the map with the
crosshair appears.
If you select From memory or From per‐
sonal POIs, either the destination mem-
ory (Y page 92) or a menu (Y page 74)
appears.
X
Select a destination and press W to con-
firm.
X
When the destination address is displayed,
select Map and press W to confirm.
The map appears.
The crosshair marks the centre of the area
that is to be avoided.
X
To move the map: slide XVY, ZVÆ or
aVb the COMAND controller.
X
To set the map scale: as soon as you turn
cVd the COMAND controller, the scale bar
appears. Turning clockwise zooms out from
the map; turning anti-clockwise zooms in.
X
Turn cVd until the desired scale is set.
X
To apply a block: press W the COMAND
controller.
A red square appears on the map.
X
To adjust the size of the square: turn
cVd the COMAND controller.
The square is enlarged or reduced.
X
To confirm the settings: press W.
The list appears. The previously selected
area to be avoided has been added and
activated.
X
Follow the instructions listed under "Option
2: the list appears".
104
Additional settings
Navigation system