Instruction Manual

X
To adjust the size of the area: turn
cVd the COMAND controller.
The area is enlarged or reduced.
X
To confirm the change: press W the
COMAND controller.
The list appears and the change is entered.
Deleting a set area
X
Select an entry in the list by turning cVd
the COMAND controller.
X
Select Options by sliding VY the
COMAND controller and pressing W to
confirm.
X
Select Delete and press W to confirm.
A query appears asking whether the entry
should be deleted.
X
Select Yes or No.
If you select Yes, the entry is deleted.
If you select No, the process will be aborted.
Compass function
In the compass view, you can see the current
direction of travel, the current height above
sea level and the coordinates of the vehicle
position, for example.
X
To switch on navigation mode: press the
Ø function button.
X
To show the menu: press W the COMAND
controller.
X
Select Position in the navigation system
menu bar by sliding VÆ and turning cVd
the COMAND controller and press W to
confirm.
X
Select Compass and press W to confirm.
Compass (example)
:
Current direction of travel
;
Current height above average sea level,
rounded
=
Current vehicle position: longitude coor-
dinates
?
Number of GPS satellites currently being
used
A
Current vehicle position: latitude coordi-
nates
B
Currently set steering angle of the front
wheels
i
To display current height ;, the system
must be able to receive at least four satel-
lites. Steering angle B can be a maximum
of 35° in both directions.
X
To exit the display: confirm Back by press-
ing W or press the % button.
Showing the map data version
X
To show the menu: press W the COMAND
controller.
X
Select Navi in the main function bar by
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
X
Select Map version and press W to con-
firm.
The map data version number is shown.
Information about new versions of the dig-
ital map can be obtained from a Mercedes-
Benz Service Centre.
106
Additional settings
Navigation system