Instruction Manual

R
convenience telephony (Y page 120)
R
telephony via the Bluetooth
®
interface
(Y page 118)
X
Select Call lists by sliding VÆ and turn-
ing cVd the COMAND controller and press
W to confirm.
X
Select Speed dial preset list and
press W to confirm.
The speed dial list appears.
X
Select the list symbol to the right of the
entry by sliding VY the COMAND control-
ler and press W to confirm.
X
Confirm Assign speed dial preset by
pressing W.
X
Proceed as described under option 1.
Making a call via speed dial
A description can be found in the "Making a
call" section (Y page 125).
Deleting a speed dial number
X
To delete a speed dial number: select
Delete speed dial preset in the
"Speed dial" menu by turning cVd the
COMAND controller and press W to con-
firm.
The speed dial number is deleted.
X
To delete all speed dial numbers: select
Delete all speed dial presets in the
"Speed dial" menu by turning cVd the
COMAND controller and press W to con-
firm.
You will be asked whether you want to con-
tinue.
X
Select Yes or No and press W to confirm.
If you select Yes, all speed dial numbers will
be deleted from the speed dial list.
If you select No, the process will be aborted.
Text message (SMS)
Information and requirements
The following conditions must be fulfilled in
order to use the functions:
Type of tel-
ephony
Conditions
Bluetooth
®
interface tel-
ephony
R
The Bluetooth
®
mobile
phone supports the
MAP Bluetooth
®
profile
(Message Access
Profile)
Convenience
telephony
R
The mobile phone is
inserted in the bracket
and switched on.
R
The PIN has been
entered.
R
The mobile phone is log-
ged into a mobile phone
network.
i
Telephony via the SAP module, see the
separate operating instructions.
When the mobile phone is connected, the 30
most recent text messages which are cur-
rently stored on the phone are loaded to the
COMAND's text message inbox and dis-
played.
i
COMAND may not load all the most
recent text messages:
This may occur in exceptional cases, for
example when using certain mobile
phones/brackets and when the mobile
phone inbox holds many text messages.
If the above conditions are met, new incoming
text messages appear in the COMAND text
message inbox. In addition, a tone sounds
and the / icon appears. The symbol dis-
appears once you have read the text mes-
sage. The ú mail symbol is displayed when
the text message memory is full. The symbol
disappears once you delete at least one text
message.
Text message (SMS)
137
Telephone
Z