Instruction Manual

X
Select a centre by turning cVd the
COMAND controller.
X
Irrespective of the option, press W to con-
firm your selection.
The address entry menu appears again. The
centre selected has been entered.
X
Start route calculation (Y page 56).
Entering a junction name
Entering a junction will delete a previously
entered house number.
X
Select Junct. (junction) in the address
entry menu by turning cVd and sliding
ZVÆ the COMAND controller and press
W to confirm.
You will see the junction list either with the
character bar (option 1) or as a selection
list (option 2).
Option 1: junction list with character bar
X
Enter a junction. Instructions for entering
characters using town input as an example
can be found in the "Entering characters in
navigation mode (entering a town)" section
(Y page 25).
Option 2: junction list as selection list
:
G icon indicating more selection options
X
Select a junction by turning cVd the
COMAND controller and press W to con-
firm.
Entries with the G icon cannot be uniquely
assigned. Another selection list is shown.
X
Select an entry by turning cVd the
COMAND controller and press W to con-
firm.
The address entry menu appears again. The
junction selected has been entered.
X
Start route calculation (Y page 56).
Selecting a destination from the des-
tination memory (e.g. My address)
Introduction
The destination memory always contains an
entry named "My address". You may wish to
assign your home address to this entry, for
example (Y page 57), and select it for route
guidance. This entry is always located at the
top of the list in the destination memory.
X
To switch on navigation mode: press the
Ø function button.
X
To show the menu: press W the COMAND
controller.
X
Select Destination in the navigation sys-
tem menu bar by turning cVd the
COMAND controller and pressing W to
confirm.
Destination entry
59
Navigation system
Z