Instruction Manual

Table Of Contents
Route display stopped (example)
:
Road name and location display
;
Distance of the crosshair from current
vehicle position
X
To get to the current vehicle position:
press W to confirm the symbol for the cur-
rent vehicle position.
X
To change the map scale: select Scale
and press W to confirm.
The scale bar appears.
X
Turn cVd the COMAND controller and
press W to confirm.
Recording the route
Notes
If you have activated COMAND and the SD
memory card has been inserted, you should
not take it out of the slot.
When you record a route, COMAND uses so-
called support points and displays the route
as a series of lines. If the route is then calcu-
lated, COMAND attempts to align the recor-
ded route with the digital map.
The support points of the route may not be on
a digitised road.
This is often the case with routes which are
drawn up using other map data and imported
via COMAND Online, e.g.:
R
routes from the Google™ special destina-
tion search (Y page 165)
R
routes from the special destination down-
load (Y page 168)
Calling up the "Routes" menu
X
Insert the SD memory card (Y page 196).
X
To switch on navigation mode: press the
Ø function button.
X
To show the menu: press W the COMAND
controller.
X
Select Destination in the navigation sys-
tem menu bar by turning cVd the
COMAND controller and pressing W to
confirm.
X
Select Routes.
Starting/ending recording
X
To start recording: select Start record‐
ing in the "Routes" menu by turning cVd
the COMAND controller and press W to
confirm.
The route is recorded and entered in a
list.#REC is displayed in red :.
X
To end recording: select End recording
in the "Routes" menu by turning cVd the
Route guidance
85
Navigation system
Z