Instruction Manual

X
To show traffic report: select a road
(area, region) by turning cVd the COMAND
controller and press W to confirm.
You will find an example of a traffic report
on (Y page 91).
X
To show TMC symbols: select TMC sym‐
bol information by turning cVd the
COMAND controller and press W to con-
firm.
Example display
:
Affected section of motorway
;
Icon for incident (traffic jam in the exam-
ple shown)
=
Icon display for the section of route affec-
ted
X
To show the next/previous incident:
select Next or Previous (if available) and
press W to confirm.
X
To show the detailed view: select
Details and press W to confirm.
X
To scroll the map: select Map and press
W to confirm.
You can move the map (Y page 61) to ena-
ble further traffic reports to be displayed.
List when route guidance is active
By default, the list shows the roads, areas and
regions that lie along the route and are affec-
ted by traffic reports.
:
To display all reports (including those not
affecting the route)
;
To have traffic reports read out on route
(Y page 91)
=
Affected roads, areas or regions (only
available when there are traffic reports for
the route)
X
To show all traffic reports: select Dis‐
play all messages and press W to con-
firm.
You will see a list of all roads, areas or
regions for which reports are available,
including those that do not affect the route.
X
To show a traffic report: select a road, an
area or a region and press W to confirm.
You will find an example of a traffic report
below.
X
To exit the list: slide XVY the COMAND
controller once or several times.
90
Dynamic route guidance
Navigation system