User's Manual

Cancelling the speed limit
No speed limit : applies here.
i
The unit for the speed limit (km/h or mph)
depends on the country in which you are
driving. In general it is not displayed either
on traffic signs or in COMAND Online.
Please take this into account when observ-
ing the maximum permitted speed.
Additional settings
Avoiding an area
General notes
COMAND Online enables you to avoid areas
you do not wish to drive through.
If you activate or deactivate a route block
while route guidance is active,
COMAND Online will calculate a new route. If
you activate or deactivate a route block while
route guidance is inactive, COMAND Online
will use the new setting for the next route
guidance.
i
Motorways within blocked areas are
always included in the route calculation.
Defining an area for the first time
Calling up the area menu
X
To switch to navigation mode: press the
Ø button.
X
To show the menu: press W the COMAND
controller.
X
Select Navi in the main function bar by
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
X
Select Avoid area and press W to con-
firm.
If you have not previously blocked an area,
a menu appears.
X
Select Using map, From memory or From
personal POIs and press W to confirm.
If you select Using map, the map with the
crosshair appears.
If you select From memory or From per‐
sonal POIs, either the destination mem-
ory or the list of categories for POIs
appears.
R
Destination memory (Y page 71)
R
List of categories for personal POIs
(Y page 86)
X
Select the desired destination or personal
POI and press W to confirm.
X
When the destination address is displayed,
select Continue and press W to confirm.
The map appears.
120
Additional settings
Navigation