User's Manual

The crosshair marks the centre of the area
that is to be avoided.
X
To scroll the map: slide XVY, ZVÆ or
aVb the COMAND controller.
X
To set the map scale: as soon as you turn
cVd the COMAND controller, the scale bar
appears. Turning clockwise zooms out from
the map; turning anti-clockwise zooms in.
X
Turn cVd until the desired scale is set.
X
To apply a block: press W the COMAND
controller.
A red square appears on the map.
X
To adjust the size of the square: turn
cVd the COMAND controller.
The square is enlarged or reduced.
X
To confirm the settings: press W.
The list appears. The previously selected
area to be avoided has been added and
activated.
You can define additional areas that you
would like to avoid (Y page 121).
Defining further areas
Calling up the list of areas
X
To switch to navigation mode: press the
Ø button.
X
To show the menu: press W the COMAND
controller.
X
Select Navi in the main function bar by
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
X
Select Avoid area and press W to con-
firm.
If you have already selected one or more
areas to avoid, a list of areas appears.
Example: list of areas
i
Available positions in the list are named
Empty and are shown in grey.
X
Select Avoid new area by turning cVd
the COMAND controller and press W to
confirm.
A menu appears.
X
Select Using map, From memory or From
personal POIs and press W to confirm.
If you select Using map, the map with the
crosshair appears.
If you select From memory or From per‐
sonal POIs, either the destination mem-
ory or the list of categories for POIs
appears.
Additional settings
121
Navigation
Z