User's Manual

X
Select Sound by sliding VÆ and turning
cVd the COMAND controller and press
W to confirm.
X
Select Surround and press W to confirm.
X
Select Logic7
®
on or Logic7
®
off by turn-
ing cVd the COMAND controller and press
W to confirm.
Depending on your selection, surround
sound is switched on or off and the menu
is exited.
X
To exit the menu without saving: press
the % back button or slide XVY the
COMAND controller.
i
Please note the following: for the opti-
mum audio experience for all passengers
when Logic7
®
is switched on, the balance
should be set to the centre of the vehicle
interior.
You will achieve the best sound results by
playing high-quality audio and video DVDs.
MP3 tracks should have a bit rate of at least
128 kbit/s.
Surround-sound playback does not func-
tion for mono signal sources, such as the
medium wave range (MW) in radio mode.
If radio reception is poor, e.g. in a tunnel,
you should switch off Logic 7
®
, as it may
otherwise switch between stereo and
mono and cause temporary sound distor-
tions.
On some stereo recordings, the sound
characteristics may differ from conven-
tional stereo playback.
i
The Logic7
®
on function creates a sur-
round sound experience for every
passenger when playing stereo recordings,
for example. It enables optimum playback
of music and films on CD, audio DVD or
video DVD with multichannel audio for-
mats, such as MLP, dts or Dolby Digital.
This results in sound characteristics as the
sound engineer intended when the original
was recorded.
i
If you select Logic7
®
off, the sound sys-
tem plays the tracks as stored on the
medium. Due to the design of the
passenger compartment, an optimum
audio experience cannot be guaranteed for
all passengers.
Bang & Olufsen sound system
You can optimise the sound in the vehicle with
the Bang & Olufsen sound system and the
True Image™ sound technology. The Sound
Mode function enables you to focus the selec-
ted sound setting within the vehicle.
The example describes how to set the opti-
mum sound for radio mode.
Selecting the sound setting for True
Image™
X
Press a number key, such as $.
X
Select Sound by sliding VÆ and turning
cVd the COMAND controller and press
W to confirm.
X
Select Bang&Olufsen and press W to con-
firm.
A menu appears. A # dot marks the current
setting for True Image™.
X
Select Reference or Surround and press
W to confirm.
R
Reference
This setting provides a crisp, clear, luxury
high-end sound setting for a studio atmos-
phere in your vehicle.
R
Surround
Basic functions of COMAND Online
33
At a glance