User's Manual

Entering a destination using the map
Calling up the map
Map with crosshair
:
Current vehicle position
;
Crosshair
=
Details of the crosshair position
?
Map scale selected
X
To switch to navigation mode: press the
Ø button.
X
To show the menu: press W the COMAND
controller.
X
Select Destination in the navigation sys-
tem menu bar by turning cVd the
COMAND controller and press W to con-
firm.
X
Select Using map and press W to confirm.
The map with crosshair is shown.
Display = depends on the settings selected
in "Map information in the display"
(Y page 114). If the digital map contains the
necessary data, the current road is shown. If
the geo-coordinates display is switched on,
the geo-coordinates of the crosshair are
shown.
Moving the map and selecting the des-
tination
X
Call up the destination entry via the map
(Y page 73).
X
To scroll the map: slide XVY, ZVÆ or
aVb the COMAND controller.
X
To set the map scale: as soon as you turn
cVd the COMAND controller, the scale bar
appears.
X
Turn cVd until the desired scale is set.
Turning clockwise zooms out from the map;
turning anti-clockwise zooms in.
X
To select a destination: press W the
COMAND controller.
If the crosshair lies outside the digital map,
COMAND Online uses the nearest digitised
road for route calculation. The The cross‐
hair is outside the digitalised
area of the map message is shown. If the
crosshair is located over a body of water,
you will see the message: The destina‐
tion is located in a body of
water. Please select another des‐
tination.
X
Select OK and press W to confirm.
If the destination is within the limits of the
digital map, COMAND Online attempts to
assign the destination to the map.
If the destination can be assigned, you will
see the address entry menu with the
address of the destination. If not, you will
see the Destination from map entry.
X
To start route calculation: select Start
and press W to confirm.
Entering a destination using geo-coor-
dinates
Geo-coordinates input menu
Entering a destination
73
Navigation
Z