User's Manual

Entering waypoints
Introduction
You can map the route yourself by entering
up to four waypoints. The sequence of the
waypoints can be changed at any time.
COMAND Online provides a selection of pre-
defined destinations in eight categories for
this purpose, e.g. FILLING STATION or COF‐
FEE SHOP. You can also use the destination
entry options to enter waypoints.
Creating waypoints
Waypoint menu (with destination, without way-
point)
X
To switch to navigation mode: press the
Ø button.
X
To show the menu: press W the COMAND
controller.
X
Select Destination in the navigation sys-
tem menu bar by turning cVd the
COMAND controller and press W to con-
firm.
X
Select Way points and press W to con-
firm.
The destination is entered into the way-
points menu. The waypoints are not yet
entered.
X
Confirm Add: by pressing W the COMAND
controller.
X
Select the category or Other by turning
cVd the COMAND controller and press
W to confirm.
After selecting a category, the POIs which
are available along the route and in the
vicinity are displayed.
COMAND Online first searches for destina-
tions along the route. If there are no desti-
nations available there, it then continues
searching for destinations within a radius
of approximately 100 km of the vehicle
position.
X
After selecting Other, select one of the
destination entry options from the list.
Selection Step
Address entry
X
Enter a destina-
tion by address
(Y page 65).
From memory
X
Select a destina-
tion from the des-
tination memory
(Y page 71).
From last desti‐
nations
X
Select a destina-
tion from the list
of last destina-
tions (Y page 72).
From POIs
X
Select a POI
(Y page 78).
Entering a destination
75
Navigation
Z