User`s manual

EN-10
This product is designed to be resistant to adverse environmental conditions.
However, note the following for longer use.
• The display quality of the panel (such as brightness, uniformity, and afterimage) degrades, depending largely on the usage and
installation condition.
Pay attention to the following points and use the product correctly.
The guaranteed operating temperature and relative humidity ranges are 5°C to 35°C and 20% to 80%.
• Be careful not to subject the product to static discharge. Otherwise it may be broken.
• To prevent damage to the LCD panel and backlight, do not apply strong vibrations, pressure, and impacts to the product.
• Don’t press the panel surface.
• The panel surface is very soft and vulnerable. Gently wipe off dirt and dust from the panel surface with a dry soft cloth or lint-free
sheet. Avoid using the same cloth repeatedly.
• When dirt and dust cannot be removed from the panel surface with a dry soft cloth, wipe them off gently using a soft cloth moist-
ened with 5% ethyl alcohol.
Installation environmental conditions
The guaranteed operating temperature and relative humidity ranges are 5°C to 35°C and
20% to 80%.
• When the bright mode is set to NORMAL, the screen brightness is automatically lowered (to 80%), reducing the heat generation
of the product. The factory default is NORMAL.
[Control application]
[CONFIGURATION] → [BRIGHT MODE] NORMAL/BRIGHT
• Keep the ambient temperature low and install the product in a well-ventilated place.
1. When the fan mode is set to FULL, the effect of lowering the temperature of the product
is increased.
• The built-in fan always rotates at a high speed.
[Control application]
[CONFIGURATION] → [FAN MODE] NORMAL/FULL
2. Installation conditions
For standard installation
• Install the product on a fl at surface. When the panel surface bends or curls, uneven brightness and uneven color tend to be
caused, degrading the screen uniformity.
• For good ventilation, leave space around the product as much as possible.
• Don’t block the intake and exhaust vents in the rear of the product.
For wall mounting
• This product can be mounted directly on the wall by its rear.
• The maximum allowable tilting angle is 15 degrees forward.
• Mount the product on a fl at wall. When the panel surface bends or curls, uneven brightness and uneven color tend to be
caused, degrading the screen uniformity.
• For good ventilation, leave space around the product as much as possible.
• Don’t block the intake and exhaust vents in the rear of the product.
3. Installation in a place where the temperature changes abruptly
• The LCD panel is made of materials vulnerable to thermal shock. Avoid installing the product in a place where the tempera-
ture goes down to 0°C or lower when it is stopped. Due to the difference in the temperature between when the product is
operating and stopped, the LCD panel materials may be subject to thermal impact and deterioration may be accelerated.
4. Dew condensation
• Don’t use the product with condensation forming inside the product. Otherwise it may be broken.
• Especially, depending on the environment where the product is transported or stored in a warehouse, condensation may
form inside the product when it is unpacked. In such a case, evaporate the moisture completely before turning on the prod-
uct.
5. Sideways installation and top side down installation
• Use of the product installed on its side or its top side down isn't guaranteed.