Specifications

3- 38
3. REPLACEMENT PROPOSAL FROM A-MOTION TO STAND-ALONE MOTION
13) The new project creation dialog box appears. Select "Yes".
Although the sequence program has been converted by following this procedure, it may not be operated
correctly. For the program modifications, refer to Section 5 and later.
To open the file in which CPU has been changed with GX Developer2 again, select "Open Other Data"
--> "Open Other Project" from the "Project" tab.
(2) Conversion of ladder program for A-Motion created by GX Developer
The following describes an example of the procedure for replacing a sequence project using GX
Developer. Always backup the project before the replacement.
1) After starting GX Works2, select "Start GX Developer" from the "Project" tab.
2) The following shows the conversion of a sequence program for A-Motion created by GX Developer
(GPPW file format).
3) After GX Developer is started, select "Open project" from the "Project" tab.
4) Select the file to be converted, and select "Open".
For the following conversion operations, refer to
(1) SW3RNC-GSVE/SW2□-GSVE ladder program
conversion procedure after 8)
.