Specifications

4- 37
4. REPLACEMENT FROM A-MOTION TO QN-MOTION
5. USING A/QnA->Q CONVERSION SUPPORT TOOL FOR SEQUENCE PROGRAMS
To confirm the converted content of the sequence program,
use "A/QnA->Q conversion support tool".
Please download and install the A/QnA->Q conversion support tool from Mitsubishi Electric FA Site.
For details, refer to A/QnA->Q Conversion Support Tool Operation Guide on the same page.
To download the tool, access the Mitsubishi Electric FA Site
(http://www.mitsubishielectric.co.jp/fa/index.html) and as follows.
http://www.mitsubishielectric.co.jp/fa/download/software/search.do?mode=software&kisyu=%2Fplca&lan
g=2&select=0&softid=0
5.1 Preparation for Using Support Tool
To use the support tool, prepare the following.
1) Diversion source sequence program (for comparison)
2) Target sequence program (program converted for Qn(H)CPU)
3) A/QnA->Q conversion support tool (Obtain this tool from Mitsubishi Electric FA Site.)
4) A/QnA->Q Conversion Support Tool Operation Guide (Obtain this guidebook from Mitsubishi
Electric FA Site.)
5) GX Developer (GX Works2)
Caution
Convert 1) into a project whose CPU type is changed to A2SH or A3U and save the project using GX
Developer as follows. The conversion method is the same as the one described in "2.4.3 Program
Diversion Procedure in PLC CPU Side".
• For A171SHCPUN and A172SHCPUN
Select "ACPU" for PLC series and "A2SH" for PLC type in the "Change PLC type" dialog box, and
select "OK".
• For A173UHCPU
Select "ACPU" for PLC series and "A3U" for PLC type in the "Change PLC type" dialog box, and
select "OK".
*
This operation is necessary to use the A/QnA->Q program conversion support tool.
A/QnA->Q conversion support tool
Analysis result Index file
File for GX Developer
Statements are added in
the file after conversion.
File before conversion
File after conversion