Specifications

2- 37
2. REPLACEMENT PROPOSAL FROM A-MOTION TO QDS-MOTION
5. USING A/QnA->Q CONVERSION SUPPORT TOOL IN SEQUENCE PROGRAM
To confirm the converted content of the sequence program,
use "A/QnA->Q conversion support tool".
Please download and install the A/QnA->Q conversion support tool from Mitsubishi Electric FA Site.
For details, refer to A/QnA->Q conversion support tool guidebook in the same page.
To download the tool, access the Mitsubishi Electric FA Site
(http://www.mitsubishielectric.co.jp/fa/index.html) and as follows.
http://www.mitsubishielectric.co.jp/fa/download/software/search.do?mode=software&kisyu=%2Fplca&lan
g=2&select=0&softid=0
5.1 Preparation for Using Support Tool
To use the support tool, prepare the following.
1) Source sequence program (for compare)
2) Target sequence program (converted program in QnUD(E)(H)CPU)
3) "A/QnA->Q conversion support tool" (please get it from Mitsubishi Electric FA Site)
4) "A/QnA->Q conversion support tool guidebook" (please get it from Mitsubishi Electric FA Site)
5) GX Developer (GX Works2)
Caution
Convert 1) into a project whose CPU type is changed to A2SH or A3U and save the project using GX
Developer as follows. The conversion method is same as "Section 2.4.3 Program diversion procedure in
PLC CPU side"
• A171SHCPUN and A172SHCPUN
Select "ACPU" for PLC series and "A2SH" for PLC type in the "Change PLC type" dialog box, and
select "OK".
• A173UHCPU
Select "ACPU" for PLC series and "A3U" for PLC type in the "Change PLC type" dialog box, and select
"OK".
* This operation is necessary to use A/QnA->Q program conversion support tool.
File before conversion
File after conversion
A/QnA->Q conversion support tool
Analysis result Index file
Add statement to file after
conversion in GX
Developer file