User`s guide

XEN OWNER'S HANDBOOK 1/7
Introducing the Apricot XEN
Chapter 1
1 AC power outlet: where the monitor power cord
can plug in. Only Apricot-approved monitors should
be powered from this outlet.
2 voltage selection switch: the Apricot XEN can be
set to operate with a 100-120 volt or 220-240 volt AC
power supply.
3 AC power inlet: where the system unit AC power
cord plugs in.
4 keyboard port: connect the keyboard to this port.
5 mouse port: connect the (optional) Apricot mouse
to this port.
6 serial port 1: (110 baud to 14.4k baud): typically used
for connecting an external modem or a serial printer
signal cable.
7 serial port 2: (110 baud to 14.4k baud): typically used
for connecting an external modem or a serial printer
signal cable.
8 parallel port that supports EPP and ECP
features: typically used for a printer signal cable.
9 monitor port: connect the monitor signal cable to
this port (if you are using the on-board video controller).
10 casing screws: loosen these to remove the top cover.
11 security loop: you can feed a security chain or cable
through this loop and secure it to prevent theft of the
system unit.
12 blanking plates: for Industry Standard Architecture
(ISA) expansion card slots.
13 air vent: do not block this vent or the system will
overheat.