User`s guide

3/18 XEN OWNER'S HANDBOOK
Operating the Apricot XEN
Chapter 3
2. If there is a protective film on the centre of the caddy
lid, remove it before using the caddy.
3. To open the caddy, press the tabs on both edges at the
end opposite the shutter.
4. Set the disc, with its label upward, in the caddy. Handle
the disc only by its edge.
5. Close the lid of the caddy firmly.
6. Insert the caddy into the slot of the drive with the
disc’s label facing up and the arrow on the caddy
pointing towards the drive (that is, shutter end
foremost). Push the caddy in until it is completely
swallowed up by the drive.
The drive begins reading the disc’s table of contents. The drive’s
activity indicator lights while the table of contents is being read.
When the activity indicator goes out, the drive is ready for use.
If the activity indicator remains on, this may indicate that the
disc is not properly positioned within the caddy. In this case,
press the EJECT button to remove the caddy and try again. If the
problem persists, consult your Apricot supplier or an authorized
Apricot maintainer.
Note too that the software controlling the CD-ROM drive may
be able to prevent the insertion of a disc.