User`s guide

6/4 XEN OWNER'S HANDBOOK
Using the SETUP utility
Chapter 6
Standard CMOS SETUP
Date Specifies the system date. This is the date used by the operating
system. It can also be set from the Windows Control Panel or
at the DOS prompt.
Time Specifies the system time. This is the time used by the operating
system. It can also be set from the Windows Control Panel or
at the DOS prompt.
Floppy Floppy drive A: is always fitted in this implementation and is
drive A: always a 1.44 MB, 3.5-inch drive.
Floppy If a second floppy is present, select the correct size and type.
drive B: In this implementation if a second floppy is fitted it will normally
be a 1.2MB 5.25" drive. The default for this option is
not installed.
Drive C, D, There are three choices for configuring each IDE hard disk
E, F: type drive. In this implementation only drives C: and D: are supported.
The three choices are:
1. Auto Configure: the BIOS automatically interrogates
the hard drive and configures it appropriately.
2. User Type 1: allows you to explicitly configure the
hard drive if the drive is not supported by Auto
Configure.
3. User Type 2: allows you to explicitly configure a second
type of hard drive if the drives are not supported by
Auto Configure.
For drives of capacity less than 528 Mbytes this option should
be set to Auto, and the IDE LBA translation option in Advanced
CMOS SETUP must be disabled.
For the Quantum LPS540A drive this option should be set to
User Type 1, and configured with 1024 cylinders, 16 heads and
63 sectors per track. The IDE LBA translation option in Advanced
CMOS SETUP must be disabled.