Owner's manual

1
Connection settings Value
Baud Rate 9600 [bps]
Data Bits 8 [bits]
Parity None
Stop Bits 1 [bit]
Flow Control None
Emulation settings Value
Emulation ANSI
ASCII settings Value
ASCII sending
Sending line ends with line feeds Enable
Echo typed characters locally Enable
Line delay (milliseconds) 400
Character delay (milliseconds) 0
ASCII Receiving
Append line feeds to incoming line ends Disable
Force incoming data to 7-bit ASCII Disable
Wrap lines that exceed terminal width Enable
Controlling the projector using a personal computer
This projector can be controlled by connecting a personal computer with RS-232C terminal.
PC-controllable functions :
• Turning the power ON or OFF
• Changing input signals
• Menu setting
Connection
S-VIDEO
RS-232C
Y
G(Y)
Cb/Pb Cr/Pr VIDEO
DVI
B(Cb/Pb) R(Cr/Pr) H/HV V
to RS-232C terminal
to SERIAL port
RS-232C cable
D-SUB 9P D-SUB 9P
Important:
• Adapters may be necessary depending on the PC connected to this projector. Contact your dealer for details.
• Make sure that your computer and projector are turned off before connection.
• Turn on the personal computer and put the control software in the standby state before turning on the projec-
tor.
• This projector uses RXD, TXD and GND lines for RS-232C control.
• For RS-232C cable, the reverse type cable should be used.
1) Communication setting
HOME THEATER DLP™ PROJECTOR
HC2000