Datasheet

POINT
Parameter Batch Setting Program Development
Setting parameters for each sensor can be difficult as setting
methods can vary between setup tools. However, by using
MELSOFT Navigator and GX Works2, the parameters for different
iQSS
✽1
compatible sensors can be setup all from the same setup
screen. There’s no need to use a dedicated tool for each sensor,
resulting an efficient way of setting various sensors all in one operation.
In addition, sensors supporting CC-Link and AnyWireASLINK
✽2
networks, can be detected automatically within the system
configuration diagram.
✽
1 Innovative solution for reducing TCO. iQ Sensor Solution
✽
2
Sensor network that centrally monitors (visualizes) the sensor
statuses from the programmable controller, and contributes to
improving operating rates and reducing engineering time.
✽
3 Refer to the iQSS catalog for further details. (Sensor Solution
iQ Sensor Solution)
✽
4
AnyWireASLINK products are not available in some countries.
Please consult your local Mitsubishi Electric representative for details.
One Tool to set parameters
even between different
sensor manufacturers
POINT
Reduce sensor setup time!
Automatic detection of connected sensors within the system configuration diagram.
Sensor Parameter Setting Program Development
Apply parameters from the system configuration to
each station’s programmable controller/GOT in one shot!
Parameter setting
information in system
configuration
Applied in batch onto each
development tool’s data
GOT
(GT Works3)
Programmable
controller
(GX Works2)
Motion
controller
(MT Works2)
Just when you thought you were finished, you
have to set the parameters for the next system...
In the programming stage, setting the parameters
for multiple systems is bothersome.
With MELSOFT Navigator, the information set in
the system configuration is applied in batch onto
each GX Works2, MT Works2 or GT Works3
project. There’s no need to start each software
and check the consistency.
✽
Detailed parameters must be set with each tool.
Batch set parameters for multiple
systems.
MELSOFT
collaboration!
Apply parameters onto each software in batch!
Parameters are automatically generated from network configuration and module configuration.
No need to individually setup each sensor
using proprietary setup tools
Convenience!
Select the sensor icon to
set with unified operations
Set parameters for different
sensors on one screen
Automatically generate the system configuration
diagram by detecting connected sensors
Connect and
view with One Tool!
12