User guide

24-
Messages/Text editing
The multitap/multipress method
A brief press on a key displays the first character associated with the key and shows the other
available characters at the top of the display. Here is the list of the available characters (the
available characters list is language dependent):
To enter text, press the key bearing the required character until it appears in the display. Hold-
ing the key displays the figure corresponding to the key. If you need to use two characters from
the same key, wait for a few seconds after entering the first character (until the key characters
on the upper part of the screen are cleared) or press the right arrow key before pressing the
key again.
Correct mistakes by a short press on the [Clear] key.
Holding the [Clear] key deletes all the text. Use the left or right arrow keys to move the
cursor in the text.
Multitap method:
KEY CHARACTER
Lower case Upper case
. , - ' @ : ?/_1
a b c 2 A B C 2
d e f 3 D E F 3
g h i 4 G H I 4
j k l 5 J K L 5
m n o 6 M N O 6
p q r s 7 P Q R S 7
t u v 8 T U V 8
w x y z 9 W X Y Z 9
0 0
Short press: Swap between the Lower case and the next character toggle mode.
Long press: Swap between the Upper case, Lower case.
Short press: to enter a space.
Long press: to access special characters.
Short press: moves the cursor through the text one place to the left or to the right.
Long press: moves the cursor to the text beginning or end.
To move the cursor to the text beginning or end.
Swap between the Multitap/Multipress method and the T9 text input.
Example To type Card:
Press the [Menu/T9] key and select Messages.
Select SMS.
Select Write new.
Fill in the To field (see “Sending a new SMS message”, page28).
In the Text field, press on the [Menu/T9] key until is displayed, or select
Options, then Input mode and choose Multi-tap.
Press briefly three times, C is displayed.
Press until is displayed. Press once, a is displayed
Press three times, r is displayed
Press once, d is displayed. The word Card is now displayed.