Instruction manual

20
Draining
The unit automatically shuts down and the Tank Full lamp is lit when the tank is full.
Empty the tank.
When the tank becomes full, the FULL lamp lights.
Tank Full lamp lights.
(The unit beeps continuously).
The CURRENT HUMIDITY indicator goes out.
Airfl ows stop after air is blown for approximately 2 minutes.



Information
After removing the water and replacing the
tank, the Tank Full lamp will go off, and the unit
will automatically return to operation mode.
When the Tank Full lamp is lit, no operation but
ON/OFF is possible.
When using the OFF timer, you are only
notifi ed by the FULL lamp lighting.



Remove the water tank.
1
Grasp handle
and slide out.
Hold the tank this way
Slide the tank lid to open the
tank and then empty the water.
2
Pour the
water out as
shown.
Tank lid
Slide the tank lid to close the
tank.
3
Insert the tank all the way in
while supporting the unit.
4
Tank guard
Make sure the tank is
inserted correctly
Tank
Make sure the tank is
not broken or cracked
A beep sound is heard. 
Information
Secure the lid and guard properly or else the
tank may become stuck.
If the tank is not installed correctly, the tank full
light will come on, and the unit will not operate.


Note
Do not remove or dismantle the fl oating element
in the tank. If it is removed, the unit cannot detect
when the tank is full, and this could result in
leakage.
e_mj_15bx_a1.indb 20e_mj_15bx_a1.indb 20 2008/08/19 17:58:492008/08/19 17:58:49