Instruction manual

16
Swing louvre function
(how to read the swing monitor)
The louvre can be made to swing. Select from the 5 possible settings to suit the purpose.
Press
¡ Starts swing operation.
¡ The swing monitor is displayed.
The swing operation stops when the power
cord is unplugged.
This indicates the range of louvre swing.
(The louvre and monitor do not move in
synchronization.)
Stop swing
operation
WIDE
UPWARD
LOW AIR
OUTLET
REAR
With each press
of the button
∞ The level of noise emitted from the unit varies according to the angle of the air-flow.
∞ The louvre may stop up to a maximum of 8 seconds to correct its position, after which it will start moving
again.
∞ If the louvre is knocked out of the desired angle, readjust by following the above steps.
Information
Objective Recommended swing setting Explanations of the swing modes
Convenient for
drying carpets
or beds.
To stop the
louvre at the
desired angle
To cover the
entire room
For drying
clothes, etc.
Swing speed is automatically controlled to send
air at washing from the all angles.
The louvre swings from the UPWARD position
through to the REAR position in order to send air
to all corners of the room.
The louvre stops in a vertical position. The swing
monitor turns off.
To change the louvre to a desired angle, wait until
the louvre stops, then adjust by hand.
The louvre moves slowly through the
last 30° of the swing, as the time
taken to traverse the rear arc is
shorter than that for the upward arc
when moving at a constant speed.
The swing function is not available.
Adjust the angle manually (from
three possible positions).
When using the low air outlet, do not
close the louvre, as it needs to open
slightly to make directional
adjustments.
¡Stop swing operation
¡WIDE
¡UPWARD
¡REAR
For directing
air into a
closet
¡LOW AIR OUTLET
Move the louvre
from the sides.
Depending on the angle of the louvre, some air may
blow out of the low air outlet.
30°
e_mj_e26vx_a1(01_19)_e33.qx 05/10/13 6:31 PM Page 16