User's Manual

70
Voice/Videophone Calls
Setting to disconnect/continue/hold a call by closing the FOMA terminal Close Setting
･ This function does not operate during 64K data communication or packet communication.
･ You can end a PushTalk call by closing the FOMA terminal. Use PushTalk Close Setting to set it.
1
m8572 z 1 - 3
INFORMATION
● When you close the FOMA terminal during a call using the Flat-plug Earphone/Microphone with Switch (optional) or a
handsfree device (available in market), the call continues regardless of this setting if the settings is made to play sounds
from the connected device. Even if you remove the Flat-plug Earphone/Microphone with Switch (optional) or handsfree
device in this state, the call will continue.
● When you close the FOMA terminal while recording a message, the recording continues regardless of this setting.
● This setting applies when you close the FOMA terminal while recording a talking voice memo or video memo. When On
hold is set, the contents recorded just before putting a call on hold are saved.
Adjusting the volume of the other party’s voice during a call Listen Volume
･ The volume of the other party’s voice can be adjusted from level 1 (lowest volume) to level 6 (highest
volume).
･ The volume changed while talking is retained even after the call is ended or the power is turned off.
1
% during a call z O to adjust the volume
The volume is set automatically by pressing o or waiting for a while after you stop key operations.
･ To turn up the volume: u or r
･ To turn down the volume: d or l
･ During a videophone call, press
%
to adjust the volume.
INFORMATION
● How to adjust the earpiece volume in standby, and the sounds to which the earpiece volume applies ☛P128
Default Continue
End the call：Ends the call.
Continue ：Continues the call.
On hold ：Puts the call on hold. The other party hears a guidance (on-hold tone).
Default Level 4